Characteristics :
Example of a part with threaded, knurled, and grooved sections.
Total length:160 mm
Characteristics :
Example of a part extruded at both ends.
Total length: 330 mm
Characteristics :
Example of a long D-shaped shank.
Total length: 150 mm
Characteristics :
Example of a long, hollow part with a through hole.
Total length: 50 mm
Characteristics :
Example of a long part with an elliptical flange.
Total length: 380 mm
Characteristics :
Example of a part with a spherical flange.
Total length: 320 mm
Characteristics :
Example of part with an unusually thin flange.
Total part length: 100 mm
Characteristics :
Example of a part with an eccentric flange.
Total length: 40 mm
Characteristics :
Example of a long part with two irregularly shaped flanges.
Total length: 125 mm
Characteristics :
Example of a long part with two flanges and a threaded section.
Total length: 110 mm
Characteristics :
Example of a part with a countersunk head and a middle flange.
Total length: 120 mm
Characteristics :
Example of a part with three flanges (three or more flanges also possible).
Total length: 150 mm
Characteristics :
Example of a long part with a bend at its end.
Total length: 220 mm
Characteristics :
Example of a long part with a bend at its end.
Total length: 120 mm
Characteristics :
Example of a long part with multiple ends.
Total length: 60mm
Characteristics :
Example of a part with a J-shaped bend.
Total length: 50 mm
Characteristics :
Example of a combination finned and bent part.
Total length: 150 mm
Characteristics :
Example of a part with a flattened section (thumb bolt).
Total length: 50 mm
Characteristics :
Example of a part with a flattened section made from a difficult-to-cold-form material.
Total length: 90 mm
Characteristics :
Example of a part with flattened sides on its shank.
Total length: 100 mm
Characteristics :
Example of a part with a toothed section on the side of its shank.
Total length: 90 mm
Characteristics :
Example of a part with a wide groove and a chamfered tip.
Total length: 330 mm
Characteristics :
Example of a part tapered at both ends with a long diamond knurled section in between.
Total length: 50 mm
Characteristics :
Example of a part with two knurled and one threaded section.
Total length: 50 mm
Characteristics :
Example of long part with a side hole, an elliptical flange, and flat portions on its shank.
Total length: 180 mm
Characteristics :
Example of a part with a combination of a flattened section, a hole, and a bend.
Total length: 70 mm
Characteristics :
Example of a part with a combination of a flattened section, bends, a side hole, a middle flange, and a thread.
Total length: 80 mm
Characteristics :
Example of a part with washer assembly.
Total length: 80 mm
Characteristics :
Example of a part combining plastic molding at one end and a sharp point at the other.
Total length: 420 mm
Characteristics :
Example of a part with a specialized surface finish (Dacrotized) and a plated head.
Total length: 220 mm